Options Description
Paper Feed Adjust Use this setting if you are unable to resolve banding issues
even after head cleaning and alignment. Select one of the
following:
Pattern: prints an adjustment pattern that you can
measure and then enter the measured distance.
Value: lets you choose an adjustment between –0.70 and
+0.70%. Select a higher value to reduce dark bands, or a
lower value to reduce white bands.
Paper Suction Set from –4 to 0 to increase the gap between the print head
and thin or soft paper. If print quality is reduced or media
does not feed correctly, you may need to lower the suction.
Roll Paper Tension Select High or Extra High if paper wrinkles during printing.
Remove Skew Select On to enable paper skew reduction.
Setting Name Enter a name up to 22 characters for the custom paper
settings.
Restore Settings Select Yes to return all settings for the selected custom
paper to their default values.
Parent topic: Using the Control Panel Menus
Related tasks
Loading Media
Saving Sets of Media Settings
Adjusting the Media Feed
Maintenance Menu Settings
The Maintenance menu lets you run nozzle checks, cleaning cycles, and other maintenance operations.
You can access the menu directly by pressing the maintenance button.
Caution: Follow the instructions in the topic links below the table to use these menu settings correctly.
41
To Next Page
Loading...
