7. While supporting the tank cover holding plate, use the large hexagon wrench to remove the three
screws securing the plate. Then remove the plate.
Parent topic: Moving or Transporting the Product
Related tasks
Attaching the Media Guide Bar
Setting Up the Product After Moving
Follow these steps to set up the product after moving it.
1. Verify that the location is suitable for installation.
2. Reattach the media guide bar, if you removed it.
3. Perform parallel adjustment for the media feeding unit and auto take-up reel as necessary.
4. Install the waste ink bottle.
5. Connect the power cable to an electrical outlet and turn on the printer.
6. Load media in the product.
7. Perform a nozzle check and confirm that there are no clogged nozzles.
8. Align the print head and check the print quality.
Parent topic: Moving or Transporting the Product
Related tasks
Replacing the Waste Ink Bottle
138
To Next Page
Loading...
