Solving Media Skew Problems
If media skew is detected by your product, perform the parallel adjustment procedure to ensure that the
media is fed straight into the product and onto the auto take-up reel.
Note: Also perform the parallel adjustment procedure after you have moved the printer.
In addition to parallel adjustment, do the following to avoid media skew problems:
• Set the auto take-up reel to roll the media with the printable side in.
• Use media at least 36 inches (91.4 cm) wide.
• With thick media, set the software RIP to 3 passes or higher.
Parallel Adjustment Tools
Adjusting the Media Feeding Unit
Adjusting the Auto Take-up Reel
Parent topic: Solving Problems
Parallel Adjustment Tools
Use these tools to perform the parallel adjustment procedure.
Parent topic: Solving Media Skew Problems
Adjusting the Media Feeding Unit
Two people are required for parallel adjustment: one in front of the printer and one in back.
155
To Next Page
Loading...
