Caution: Always move the print head as described here. Do not move the print head manually or you
may cause your product to malfunction.
1. When the product is turned on, press the maintenance button on the control panel.
You see the Maintenance menu.
2. Press the up or down arrow buttons on the control panel to select Head Maintenance and press the
OK button.
The print head moves into maintenance position.
3. Perform your maintenance task as necessary.
Note: After 10 minutes, a alarm sounds to warning you that the print head is still in maintenance
position. You also see a notice on the LCD screen telling you to clean the print head after
maintenance. After completing your maintenance task, press the OK button to clean the print head.
The alarm sounds again at 10 minute intervals if the print head is not in the home position.
Parent topic: Preparing for Maintenance
Stirring High Density Black Ink
To prevent sedimentation and incorrect colors in your printed media, stir the High Density Black ink in
the ink tank once a week.
1. Open the ink inlet cover for the High Density Black ink shown here.
85
To Next Page
Loading...
