38 Solving Problems
The left network light is
flashing and the P power
light is flashing
Printer is receiving data or printing while connected to a
network
The left network light is on The wireless LAN is connected
The right network light is
on
The Ethernet LAN is connected
The right network light is
flashing
An error occurred during WPS/AOSS push button
setup. Adjust your settings and try again. Move the
printer closer to the access point. Make sure the
access point is also in setup mode.
An attempt was made to connect to a wireless network
while an Ethernet cable was connected. Remove the
Ethernet cable before attempting to connect to a
wireless network.
Both network lights are
flashing simultaneously
WPS PIN code entry is in progress or the printer is
preparing a firmware update
Both network lights are
flashing alternately
WPS push-button setup is in progress or the printer is
starting up
The H ink light is on An ink cartridge is expended or not installed correctly,
or is not compatible with the printer. Replace or
reinstall the cartridge (see page 31).
The H ink light is flashing Ink in a cartridge is low. You can continue printing, or
check which cartridge is low (see page 29) and replace
it (see page 31).
Light status Problem and solution
To Next Page
Loading...
