176
Parent topic: Print Head Maintenance
Related references
Optional Equipment and Replacement Parts
Environmental Specifications
Related tasks
Replacing the Borderless Maintenance Box
Replacing the Maintenance Box
Removing and Installing Ink Cartridges
Cleaning the Print Head Using the Product Control Panel
You can clean the print head using the control panel on your product.
1. Load roll or cut sheet paper in the printer.
2. Make sure the correct paper type is selected.
3. Select maintenance > Head Cleaning.
4. Select Start to start the cleaning cycle.
Note: A typical head cleaning cycle takes about 5 to 6 minutes.
The power light begins flashing. When the cleaning cycle is finished, the power light stops flashing
and a confirmation screen appears.
Caution: Never turn off the product during a cleaning cycle or you may damage it.
5. Select Yes to print a nozzle check pattern.
To Next Page
Loading...
