53
2. Remove any roll media adapters from the black and gray paper stops, if necessary.
3. Slide the spacer all the way onto the spindle until it reaches the gray paper stop on the other end.
Make sure the holes in the spacer and paper stop line up exactly.
To remove the spacer, remove the black paper stop from the spindle and then remove the spacer by
holding its outer edge and pulling it straight off.
Parent topic: Roll Paper Handling
Related references
Borderless Paper Type Compatibility
Loading Roll Paper
You can load roll paper with a 2- or 3-inch core and a width of up to 17 inches (43 cm).
1. Make sure the printer is turned on.
2. On the control panel, select the icon.
3. Select How To... and follow the on-screen instructions to load roll paper.
4. Close the roll paper cover.
To Next Page
Loading...
