• Check the paper package for any additional loading instructions.
Parent topic: Loading Media
Related references
Cut Sheet Media Loading Capacity
Related tasks
Loading Paper in the Sheet Feeder
Loading Posterboard and Thick Media
Selecting the Paper Settings for Each Source - Control Panel
Selecting the Default Paper Setup Display and Error Notice Settings
Loading Posterboard and Thick Media
Use the front manual feed tray to load media with a thickness of 0.047 to 0.059 inch (1.2 to 1.5 mm).
Note: Be sure to leave at least 17 inches (43 cm) of space behind your product for the media to feed
through.
1. Turn on your product.
2. Remove any paper from the sheet feeder and close the paper support.
3. Remove any roll paper and the roll paper unit, if necessary.
4. Close the rear paper support.
46
To Next Page
Loading...
