Maintenance 114
Dampen a soft cloth in water, wring it out thoroughly, and use it to remove lint and dust
from the media holding plates on both the left and right sides and from the platen.
Checking for clogged nozzles
We recommend that you check the nozzles for clogs each time you print to ensure quality
results.
Ways to Check for Clogs
There are three ways to check for clogs.
❏ Auto Nozzle Check
The printer automatically checks for clogs at specified intervals by scanning a test
pattern with a sensor as it is being printed. If a clog is detected, the printer will perform
a pre-selected option, either Stop Printing or Continue Printing.
See “Printer Setup Menu” on page 156.
To Next Page
Loading...
