129
6. Firmly insert the tab on pad A into the slot on the grease tool and rotate the pad onto the tool.
7. Open the front cover.
8. Hold the grease tool against the back of carriage rod A and smoothly slide it back and forth across
the carriage rod to wipe off any stains.
9. Remove the stained pad from the grease tool.
10. Attach a fresh pad A to the grease tool.
11. Use one of the cleaning sticks to stir the grease in the container approximately 10 times. Then wipe
the tip of the cleaning stick on the edge of the container to remove the excess grease.
Note: Be sure to remove the excess grease from the cleaning stick or it may fall off the stick and
onto the platen or your media.
To Next Page
Loading...
