H
Clean the edges of the print head with a
cleaning stick.
I
Close the rear maintenance cover.
J
Close the port cover.
K
Press OK on the control panel.
The print head returns to its original position.
Wiping around the Cap
A
Select Maintenance - Cleaning the
Maintenance Parts - Wiping around the Cap.
The print head moves to the cleaning position.
Wait for the print head to stop moving.
B
Open the printer cover.
C
Remove the part shown in the figure.
D
Use a new cleaning stick to wipe any dirt off the
capping station.
(1) Hold the cleaning stick so that it is vertical,
and wipe the inner areas of all of the
capping stations.
c
Important:
Do not press too hard on the edges or the area
surrounding the caps with tweezers or
cleaning sticks. Doing so could cause the
parts to become deformed preventing capping
from being performed correctly.
SC-P8500DM/SC-P8500D/SC-P6500D/SC-P6500DE/SC-P6500E/SC-T7700DM/SC-T5700DM/SC-T7700D/SC-T5700D/SC-3700D/SC-T3700DE/SC-T3700E/SC-P8500DL/SC-T7700DL Series User's Guide
Problem Solver
198
To Next Page
Loading...
