C
After you have finished cleaning, close the
scanner cover.
c
Important:
Close the scanner cover right after you have
finished cleaning to prevent dust from getting
inside.
Unable to Properly Feed Originals
If the right side of the original's loading position is
incorrect, the original cannot be fed properly.
Make sure the right edge of the original is lined up
straight. If the document is not loaded straight, use the
scanner edge guide.
If the original still cannot be fed properly, change
Original Size or Scan Size to the standard size from
Auto Detect.
o
Is the original loaded with skew?
Reload the original. If the original is loaded with
skew, it cannot be fed properly.
o
Is the original folded?
Unfold the original.
If the original is folded while the printer is set to
Auto Detect in Original Size or Scan Size, the
width of the original may not be read correctly,
which may cause the original to not feed properly.
o
Clean inside of the scanner.
If the printer is set to Auto Detect in Original Size
or Scan Size, the width of the original may not be
read correctly, which may cause the original to not
feed properly.
How to Clean Inside the Scanner U “Lines Appear
on Scanned or Copied Documents” on page 209
o
You may be using an original that cannot be
placed.
See the following for details on originals that cannot
be placed.
U “Documents That Cannot Be Loaded” on
page 130
o
Is the original loaded with skew?
Reload the original. If the original is loaded with
skew, it cannot be fed properly.
Original Size or Scan Size are not
recognized correctly
o
Is Original Size or Scan Size set to Auto
Detect?
If Original Size or Scan Size is set to Auto Detect,
the size of the original may not be detected
correctly. Set Original Size or Scan Size.
o
Clean inside of the scanner.
If there is dust or dirt stuck to the scanner's glass
surface or the white board, the size of the original
may not be detected correctly. See the item below
and follow the same procedures for cleaning.
U “Lines Appear on Scanned or Copied
Documents” on page 209
Copy Results are not Enlarged to the
Width of the Roll Paper
o
Is the reduce/enlargement copy setting set
to Auto Fit Page - On?
If Auto Fit Page is set to On in Reduce/Enlarge
from the Copy menu, the scanner may not be able
to detect the size of the original correctly, and the
print result will not match the width of the roll
paper. In Advanced - Original Size, specify the size
of the original you loaded.
Scanned Image Is Misaligned
o
Change the direction that the original is
loaded.
Changing the direction that the original is loaded
may improve scan results.
SC-P8500DM/SC-P8500D/SC-P6500D/SC-P6500DE/SC-P6500E/SC-T7700DM/SC-T5700DM/SC-T7700D/SC-T5700D/SC-3700D/SC-T3700DE/SC-T3700E/SC-P8500DL/SC-T7700DL Series User's Guide
Problem Solver
210
To Next Page
Loading...
