P
Set the paper support to the position shown in
the illustration, and then open the flap.
Q
Set the paper support to the position shown in
the illustration.
R
On the control panel, press OK to feed the
paper to the take-up position.
S
Use Backward and Forward to adjust the
length of paper required for the take-up
loading.
T
Cut the leading edge of the paper as shown.
SC-P8500DM/SC-P8500D/SC-P6500D/SC-P6500DE/SC-P6500E/SC-T7700DM/SC-T5700DM/SC-T7700D/SC-T5700D/SC-3700D/SC-T3700DE/SC-T3700E/SC-P8500DL/SC-T7700DL Series User's Guide
Basic Operations
67
To Next Page
Loading...
