Messages What to do
F/W Install Error
Firmware update failed.
Restart the printer.
Turn the printer off, wait for a few minutes, and then turn on the printer again.
Use EPSON LFP Remote Panel 2 to update the firmware again.
If this message appears on the LCD panel again, contact your dealer or Epson Support.
Print head is nearing end of service
life.
The print head requires periodic replacement. The current print head is nearing the end of
its service life.
U “Parts That Are Periodically Replaced” on page 93
Auto Take-up Reel Unit stopped. Media is not correctly attached to the auto take-up reel unit.
Press the W button and select Job Cancel to cancel printing.
Flip the Auto switch on the auto take-up reel unit to Off, then flip it back and reattach the
media to the auto take-up reel unit.
U “Media Loading and Take Up” on page 55
Media Size Error
Load correct size media.
The media currently loaded is not the correct width. Raise the media loading lever and
remove the media.
The narrowest width supported by the printer is 300 mm
*
. Be sure the media is at least 300
mm wide.
If this message is displayed even though the media is the correct width, the printer may
print if Off is selected for Media Size Check.
U “Printer Setup Menu” on page 104
* The minimum supported width for ink layering is 508 mm.
Ink layering U “High Print Quality” on page 23
Media Sensor Error
Loaded media or print out has a
problem.
Refer to documentation for details.
Press W to clear the message from the display.
If the message was displayed during auto head alignment, auto feed adjustment, or auto
nozzle check, check the following.
❏ Is the current media not supported?
The above options do not produce the desired results with transparent or colored
media, or tracing paper.
❏ Are outside light sources interfering with the process?
If the printer is exposed to direct sunlight or interference from other ambient light
sources, shade the printer from these sources.
❏ Is 2.5 is selected for Platen Gap in the setup menu?
The above options are not available when 2.5 is selected for Platen Gap.
❏ Are the nozzles clogged (auto head alignment, auto feed adjustment)?
Perform head cleaning. U “Head Cleaning” on page 77
If this error is displayed under conditions other than those listed above, confirm that the
printer supports the current media.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Problem Solver
112
To Next Page
Loading...
