❏ Cleaning should also be performed if colors in the
printout are faint or missing even after head
cleaning has been performed.
Clean the parts in the following order.
(1) Print head
(2) Wiper
(3) Caps
(4) Wiper rail
Moving the Print Head
This section describes how to position the print head for
part cleaning.
c
Important:
Be sure to follow the steps below when positioning
the print head. Moving the print head manually
could cause malfunction.
Buttons that are used in the following settings
A
Confirm that the printer is on and press #.
The Maintenance menu will be displayed.
B
Use the d/u buttons to select Head
Maintenance and press the Z button.
C
Press the Z button to move the print head to the
cleaning position.
D
Open the maintenance covers at each end.
Cleaning Around the Print Head
Inspect the area around the print head and remove any
ink stains as described below.
Note the the SC-S70600 series and SC-S50600 series
have two print heads; be sure to inspect both.
A
Use a cleaning stick to wipe the areas of the print
head shown in the illustration.
c
Important:
Be sure to use a narrow cleaning stick to clean
between the nozzles (the four areas shown in
the illustration). Touching the nozzle surface
with the cleaning stick could damage the print
head. The SC-S70600 series and SC-S50600
series have two print heads; clean both.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Maintenance
81
To Next Page
Loading...
