Epson SureColor T-Series - Page 164

Epson SureColor T-Series User’s Guide
Maintenance
164
7
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
8
After replacing the cutter, press the Z button.
The cutter will return to its original position.
Ready is displayed in the control panel when the
process is complete.
!
Caution:
Do not store the cutter within the reach of
children. The cutter's blade could cause an
injury. Pay careful attention when replacing
the cutter.
c
Important:
Screw up the cutter firmly, otherwise the cut
position may be slightly shifted or skewed.