8 Raise the scanner.
9 Turn and remove the protective piece.
10 Press the sides of the protective piece, and then lift and remove it.
11 Remove the protective film from the control panel.
Note: The touchscreen will not operate if you do not remove the
protective film.
12 Remove the tape.
13 Lower the scanner.
14 Open the cut sheet cover and remove the tape inside the printer.
Epson
®
SureColor
®
T3170M/T5170M
Start Here
IMPORTANT: Before using this product, make sure you read these instructions
and the safety instructions in the online User’s Guide.
The illustrations show the SureColor T3170M, but the steps are the same for all
models, unless otherwise specified.
Note: Availability of models varies by country.
Choose a Location for the Printer
Choose a location for the printer that is near a wall outlet where the power cord
can be easily unplugged. Avoid places subject to rapid changes in temperature
and humidity. Also keep the printer away from direct sunlight, strong light, or
heat sources.
Make sure to place the printer on a flat, stable surface with enough space on
all sides (see illustrations below). The surface supporting the printer should be
wider than the space between the rubber feet on the bottom of the printer and
capable of supporting the weights shown below.
8.97 in.
(228 mm)
8.97 in.*
(228 mm*)
SureColor T3170M SureColor T5170M*
Weight: Approx. 123 lbs (56 kg)Weight: Approx. 75 lbs (34 kg)
4.13 in.
(105 mm)
4.13 in.
(105 mm)
14.57 in.
(370 mm)
1.57 in.*
(40 mm*)
22.4 in.
(570 mm)
* 5.4 in. (137 mm) of space is required when using the document support.
Unpack
1 Make sure you have these items:
Printer and roll spindle
Output tray
Ink cartridges (4)
Power cord
Document support
Limited warranty
Note:
• See the online User’s Guide for instructions on using the output tray and
document support.
• The SureColor T5170M comes with a stand and paper basket. For the
SureColor T3170M, a stand and paper basket are available as an
optional accessory (part number C12C933151). See the online User’s
Guide for instructions on assembling these parts.
WARNING: The printer requires two people to lift and move it. Make sure to
grip the printer as shown in the illustration.
Note: Do not hold the printer by its paper support.
2 Remove the plastic sheet and all tape from the outside of the printer.
3 Open the left cover.
4 Remove the tape and the protective piece.
5 Close the left cover.
6 Open the scanner cover by pressing both buttons and lifting the cover.
Warning: The scanner is heavy. Be careful when opening and closing the
scanner to avoid injuring your fingers or hands.
7 Remove the tape and close the cover. Make sure the scanner cover is
securely closed.
15 Open and fold back the roll paper cover.
16 Remove the tape and the protective pieces.
17 Close the roll paper cover and the cut sheet cover.
18 Dispose of all the tape and the protective pieces.
Install Ink Cartridges
Note:
• The printer is designed for use with Epson
®
cartridges only, not third-party
cartridges or ink.
• The cartridges included with the printer are designed for printer setup and not for
resale. After some ink is used for initializing, the rest is available for printing.
1 Connect the power cord to the printer. Route the cord through the
hooks on the back of the printer and plug the other end of the power
cord into an outlet.
2 Press the power button on the control panel to turn on the printer.
Raise the control panel if necessary.
3 Select your language on the LCD screen.
4 When you see a message about removing protective parts, select Done.
5 Select the date, time, and unit preference.
To Next Page
Need help?
General