197
1. Make sure roll paper or cut sheet paper is loaded in the printer.
Note: You need at least this much paper to print the adjustment pattern:
• Roll paper: 6.1 inches (156 mm)
• Cut sheet feeder: 2 sheets of A4 (8.3 × 11.7 inches [210 × 297 mm]) or larger, loaded one sheet at
a time
2. Press the home button, if necessary.
3. Select one of the following:
• Roll paper: Select the roll paper information area and select Media Adjust > Paper Feed Adjust
- Manual.
• Cut sheet: Select Paper Setting > Cut Sheet (1 sheet) > Media Adjust > Paper Feed Adjust -
Manual
4. Select Start to print an adjustment pattern.
The first set of adjustment patterns prints.
Note: If you are printing on roll paper with Auto Cut turned off, do not remove or pull out the paper
until the second set of alignment patterns prints.
5. Follow the instructions on the LCD screen to select the best patterns for the first set of adjustment
patterns and select OK.
The second set of adjustment patterns prints.
Note: If you are printing on cut sheets smaller than A2 (16.5 × 23.4 inches [420 × 594 mm]) size,
load the second sheet of paper.
6. Follow the instructions on the LCD screen to select the best patterns for the second set of
adjustment patterns, and select OK.
The screen displays a confirmation message and returns to the home screen.
Parent topic: Adjusting Print Quality
Related references
Paper Setting Menu
Related tasks
Loading Roll Paper
To Next Page
Loading...
