18
Chapter 1 Product Overview
Rear
1 Back cover
Open this cover if cut sheets become jammed. (“Opening the MICR Cover, Back Cover, and Scanner Cover”
on page 73, “Cut Sheet Jam”)
2 Scanner cover
Open this cover if cut sheets or an ID card becomes jammed. (“Opening the MICR Cover, Back Cover, and
Scanner Cover” on page 73, “Cut Sheet Jam”, “ID Card Does Not Come Out”)
3 Drawer kick connector
Connect the drawer cable.
4 Wire saddle
Pass the USB cable through this saddle to prevent disconnection of the cable.
5 Interface selection switch
Slide the switch to either left or right to switch between network connection mode and USB connection
mode. The default position is the left (network connection mode). (“Connecting to a Host” on page 42)
6 DC-IN connector
Connect a DC cable.
7 USB connector (Type B)
Connect a USB cable (Type B).
8 USB connector (Type A)
Connect the optional wireless LAN unit (OT-WL06).
To Next Page
Loading...
