28
Chapter 1 Product Overview
Confirmation Mode (USB connection only)
Use this mode to specify processing conditions from the application.
This mode stops the process that starts with cut sheet feeding is from the ASF and ends with cut sheet output to
a pocket, in order to receive an instruction from the application. It then restarts the process. It also can be used
to configure the no-overlap/overlap setting from the application.
Document Processing Sequence
The processing sequence changes depending on whether there is overlap operation or not.
With overlap
No-overlap: Starts send of the next cut sheet after the current cut sheet is fully in the pocket
Overlap: Starts feeding of the next cut sheet while the current cut sheet is being output to the
pocket
<First cut sheet>
Fed from the ASF
Check for double feeding
MICR reading
Ink jet printing
Capturing image on both sides
Stop of paper feeding*
Ejection of the cut sheet
<Second cut sheet>
<Third cut sheet>
Fed from the ASF
Check for double feeding
Ejection of the cut sheet
Fed from the ASF
Stop of paper feeding*
∗ Waits for a command from the
application.
To Next Page
Loading...
