36
Chapter 2 Setup
Connecting a Cash Drawer
Specifications Required for a Cash Drawer
Cash drawer specifications vary widely according to manufacturer and model. Whenever connecting a drawer
that is not one specified for this product, check to make sure that it meets the drawer specifications below.
Connecting a drawer that does not meet these specifications creates the risk of damage to the product.
• Drawer kick solenoid or other load between pins 4 and 2 or pins 4 and 5 of the drawer kick connector
• When using a drawer open/close signal, a switch must be provided between drawer kick connector pins 3
and 6
• Load resistance (by a drawer kick solenoid or others) of at least 24 Ω, and input current of no more than 1 A
• Use of only the 24 V output of drawer kick connector pin 4 for the drawer power supply
Drawer Kick Connector Connection Diagram
• Simultaneous operation of two drives is not supported.
• When sending consecutive drawer drive pulses, allow an interval between pulses that is at least
four times that of the drawer drive pulse.
F. G
+24V
Shielded
Drawer kick connector
Product
User (drawer)
Drawer open/
close switch
Drawer kick
solenoid
1
2
3
4
5
6
To Next Page
Loading...
