Epson TM-S9000II-NW - R;E Information Print Mode

60
Chapter 3 Advanced Product Use
R/E Information Print Mode
This mode prints the receipt enhancement information below, which is registered on the product.
• Auto Top Logo setting
• Auto Bottom Logo setting
• Auto Top Logo/auto Bottom Logo extended settings
Perform the procedures below.
1
Turn off the product and open the roll paper cover.
2
While holding down Button 2, press the (POWER) button to turn on the product.
3
Press Button 2 four times.
4
Close the roll paper cover.
This starts R/E (receipt enhancement) information printing.
Initialization starts after printing is complete. Next, the product transitions to its normal state (print-
ing/scanning enabled).
ON
+