61
Chapter 3 Advanced Product Use
Software Setting Mode
Use this mode to configure settings for the product's memory switches and customize values.
• Roll paper print density
• Auto paper use reduction
• Paper auto cutting after closing the roll paper cover
• Error operation setting
• Transmits the power ON information
• Communication settings
Perform the procedures below.
1
Turn off the product and open the roll paper cover.
2
While holding down Button 2, press the (POWER) button to turn on the product.
3
Close the roll paper cover.
This prints software setting mode guidance. Follow the instructions that are pro-
vided.
For details on memory switches and customize values, refer to “Software Settings” on page 48.
When your finish configuring settings, they are saved to the product and initialization starts. Next,
the product transitions to its normal state (printing/scanning enabled).
ON
+
To Next Page
Loading...
