83
Chapter 5 Handling the Product
Preparing for Transport
Perform the steps below to prepare the product for transport.
1
Turn off the power. (“Turning the Power Off” on page 71)
2
Confirm that the (POWER) LED is unlit.
3
Disconnect the DC connector from the product.
4
Remove the roll paper.
5
Remove the ink cartridge.
6
Store the ASF guide and pocket guide.
7
Pack the product so it is supported both from above and below.
Do not transport a used ink cartridge. Doing so may cause the ink to leak.
To Next Page
Loading...
