98
Appendix A Product Specifications
For Wi-Fi Interface (with OT-WL06)
Specifications
• Compliant with IEEE802.11a/b/g/n/ac (2.4 GHz or 5 GHz band).
• Infrastructure mode is supported.
Communication Standard
• IEEE802.11b (2.4 GHz)
• IEEE802.11g (2.4 GHz)
• IEEE802.11n (2.4 GHz)
• IEEE802.11a (5 GHz)
• IEEE802.11n (5 GHz)
• IEEE802.11ac (5 GHz)
Security
• WPA2-PSK
• WPA3-SAE
• WPA2/WPWPA3-Enterprise
Notes on Using Wi-Fi
• Install the product as far away as possible from devices that may cause radio interference, such as microwave
ovens in the kitchen.
• Use channels that are away from frequency bands that cause radio interference.
• Install a shielding board between this product and devices that generate radio wave interference.
• Use a frequency band that will not cause interference, either 2.4 GHz or 5 GHz.
• When setting the auto channel of the access point, make sure that this product is not set to a channel that
causes radio interference.
Before Connecting the Product via Wi-Fi
This product has not been confirmed to work with all wireless LAN devices, and operation with all wireless
LAN devices is not guaranteed. Please use this product after sufficient confirmation and evaluation in advance.
When using wireless LAN, make sure you disconnect the LAN cable. If a LAN cable is connected,
wireless LAN is disabled.
Parameter Initial setting
Communication standard Automatic
Network mode Infrastructure mode
SSID EpsonNet
Encryption type None
Passphrase None
To Next Page
Loading...
