Reference Information 4-3
Inserting direction
and endorsement
printing
Insert the check with the surface
printed with the magnetic ink
downward, following the table guide.
Endorsement printing can be
performed continuously after check
reading. In this case, the print starting
position is point A in the illustration
below.
❏
To print endorsements in the
specified area (within 38.1 mm
[1.5"] from the top), set the print
position for the last line so that it is
printed at least 3 mm (0.118")
above the bottom of the printable
area.
"DO NOT SIGN WRITE STAMP BELOW THIS LINE
FOR FINANCIAL INSTITUTION USAGE ONLY"
ENDORSE CHECK HERE :
[Units: mm (All the numeric values are typical.)]
Specified printing area
Inserting direction
38.1
8.7
A
3
To Next Page
Loading...
