B
Connect the USB cable for the authentication device to the MFD.
Note:
About NFC tags for the WF-6590:
The WF-6590 series provides NFC tags on their control panels. Authentication cards may not be read correctly when
there is an NFC tag near the authentication device.
If you are installing an authentication device on the left of the control panel of the WF-6590 series, remove the NFC tag,
and then attach the dummy panel included. Make sure the cable does not obstruct the rear cover or the cassette unit.
Operation check
The following procedures explain how to check the connection status and authentication card recognition for the
authentication device.
MFD control panel
Navigate to Setup and then select Authentication device status to display the information.
Hardware Setup Guide
3. Authentication device
14
To Next Page
Loading...
