❏ Binary
Select On when printing data that contains binary images.
e
application may send the
binary data even if the printer driver setting is set to ASCII, but you can print the data when
this feature is enabled.
❏ PDF Page Size
Select the paper size when printing a PDF
le.
If Auto is selected, the paper size is
determined based on the size of the
rst
page.
Auto Error Solver:
Select an action to perform when a 2-sided printing error or a memory full error occurs.
❏ On
Displays a warning and prints in single-sided mode when a 2-sided printing error occurs, or prints
only what the printer could process when a memory full error occurs.
❏ O
Displays an error message and cancels printing.
Memory Device:
Select Enable to allow the printer to access an inserted memory device. If Disable is selected, you
cannot read, print data in the memory device, or save data to the memory device with the printer.
is
prevents
condential
documents from being removed illegally.
Thick Paper:
Select On to prevent ink from smearing on your printouts, however, this may lower the print speed.
Quiet Mode:
Select On to reduce noise during printing, however, this may lower the print speed. Depending on
the paper type and print quality settings you selected, there may be no dierence in the printer's noise
level.
Print Speed Priority
Select O to allow the printer to match the printing speed to the paper type and print data
conditions.
is
allows you to prevent print quality from declining and paper jams.
PC Connection via USB:
Select Enable to allow a computer to access the printer when connected by USB. When Disable is
selected, printing and scanning that is not sent over a network connection is restricted.
USB I/F Timeout Setting:
Specify the length of time in seconds that must elapse before ending USB communication with a
computer aer the printer receives a print job from a PostScript printer driver or PCL printer driver.
If the job ending is not clearly dened from a PostScript printer driver or PCL printer driver, it can
cause endless USB communication. When this occurs, the printer ends communication aer the
specied time has elapsed. Enter 0 (zero) if you do not want to end communication.
Related Information
& “Loading Paper” on page 37
& “Printing Using Easy Settings” on page 48
& “Printing JPEG Files from a Memory Device” on page 96
Product Information
>
Settings Menu List
>
General Settings
415
To Next Page
Loading...
Need help?
General
