Epson WorkForce Pro WF-4720 series - Making Advanced Network Settings

Making Advanced Network Settings
You can change the network device name, TCP/IP setup, proxy server and so on. Check your network environment
before making changes.
1. Tap Settings on the home screen.
2. Tap General Settings > Network Settings > Advanced.
3. Tap the menu item for settings, and then select or specify the setting values.
Related Information
&
“Setting Items for Advanced Network Settings” on page 31
Setting Items for Advanced Network Settings
Select the menu item for settings, and then select or specify the setting values.
❏ Device Name
You can enter the following characters.
❏ Character limits: 2 to 15 (you must enter at least 2 characters)
❏ Usable characters: A to Z, a to z, 0 to 9, -.
❏ Characters you cannot use at the top: 0 to 9, -.
❏ Characters you cannot use at the bottom: -
❏ TCP/IP
❏ Auto
Select when you are using an access point at home or you are allowing the IP address to be acquired
automatically by DHCP.
❏ Manual
Select when you do not want the printer's IP address to be changed. Enter the addresses for IP Address,
Subnet Mask, and Default Gateway, and make DNS Server settings according to your network environment.
❏ Proxy Server
❏ Do Not Use
Select when you are using the printer in a home network environment.
❏ Use
Select when you are using a proxy server in your network environment and you want to set it to the printer.
Enter the proxy server address and port number.
❏ Email Server
❏ Server Settings
You can select the server from O, POP Before Smtp, or SMTP-AUTH.
❏ Connection Check
You can check the connection for e-mail server. If an error occurs when performing Connection Check, see
the explanation of the Connection Check message.
User's Guide
Network Settings
31