Epson WorkForce Pro WF-M5399 - Setting Up Password Encryption; Working with Audit Logs

198
Note: Depending on your product features, not all of the options listed below may be available.
1. Access Web Config and select Product Security > External Interface.
2. Select Memory Device and do one of the following:
• Select Disable to prevent access to a USB device or memory card.
• Select Enable to allow access to a USB device or memory card.
3. Select PC Connection via USB and do one of the following:
• Select Disable to prevent a computer from connecting to the product over a USB connection.
• Select Enable to allow a computer to connect to the product over a USB connection.
4. Click OK to save your setting.
Parent topic: Configuring Security Settings
Setting Up Password Encryption
You can set up password encryption to protect confidential information stored in the product.
1. Log in to the Web Config interface as an administrator.
2. Select the Product Security tab and select Password Encryption.
3. Select On and select OK.
A message appears about restarting the product. Select OK.
4. Turn the product off and then on again to apply the password encryption setting.
Note: The product may take longer than usual to turn on. This is normal.
Parent topic: Configuring Security Settings
Working with Audit Logs
You can enable the Audit Log feature or export audit log data using the Web Config interface. Audit logs
can be used to track security issues or identify improper usage.
1. Log in to the Web Config interface as an administrator.
2. Select the Product Security tab, then select the Audit Log setting.
3. Select ON to enable the audit log feature.
4. Select Export to export the audit log data to a CSV file, or select Delete to delete all audit logs.