What to do if eQ-3 Accessories duty cycle exceeded?
If the eQ-3 Accessories device's duty cycle is exceeded, the device will start working correctly again after a short period, which should be no more than 1 hour.
Why is the command not confirmed on my eQ-3 Accessories?
If a command is not confirmed for your eQ-3 Accessories device, it could be due to several reasons: * The receiver cannot be reached. * The receiver is unable to execute the command because of a load failure or a mechanical blockade. * The receiver might be defective.
General| Type | Temperature and humidity sensor |
|---|---|
| Radio frequency | 868 MHz |
| Max. radiated power | 10 mW |
| Communication | Radio |
| Humidity Measurement Range | 0 to 100 %RH |
Detailed steps for installing the device, including safety precautions and required knowledge.
Procedures for physically installing the device into a flush-mounted box and making connections.
Guide on how to integrate the device into the Homematic IP system using the app or control unit.
Addresses issues where device commands fail to reach or execute on receivers.
Explains the 868 MHz duty cycle limits and potential operational impacts.
Provides a reference for interpreting LED signals and error codes for diagnosing issues.
To Next Page
