1 Locate a wall stud. Place the bracket
against the wall using a level to make
sure it’s aligned, and mark the screw
holes. Remove the bracket.
2 Pre-drill pilot holes into a stud using a
9/64” drill bit. Place the bracket
against the wall with the small arrows
pointing up, and secure it to the wall
with 2 long wall bracket screws
(included) and a power drill or
Phillips-head screwdriver.
3 Remove the screw from the mount
assembly. Rotate the mount 180
degrees so the screw holes are facing
up, then reattach the screw to the
mount assembly.
To Next Page
Loading...