Erbauer EPM18-Li - Mixing

29
01
Mixing (Fig. K)
WARNING!
During operation ne dust will be generated!
Some dusts are highly inammable and explosive! Do not smoke
during operation, keep heat sources and open ames out of the
working area!
Always wear a dust mask to protect yourself against hazards resulting
from ne dust!
The mixer paddle will come to a stop during operation if the material is
too dense! Switch the product off, let it come to a complete stop, lift
the mixer paddle out of the material and inspect the material before
using the product again! A blocked mixer paddle may cause
overheating of the motor.
Hold the product rmly during operation. Do not let the mixer paddle
touch the sides of the bucket! This can cause damage to the mixer
paddle and bucket!
When using this product, maintain a rm grip on the handles with both
hands to resist starting torque. Switch the product off immediately if
the mixer paddle jams. Be prepared for high reaction torques, which
could cause kickbacks.
1. Hold the product rmly by both grip handles (1) and insert the mixer paddle (11)
into the material.
2. Set speed dial (7) at lowest speed then switch the product on.
3. Increase the speed dial (7) slowly to the required mixing speed. Doing so also
results in efcient motor cooling.
4. Move the mixer paddle (11) through the material until it is evenly and completely
mixed.
5. Switch the product off. Let the mixer paddle (11) come to a complete stop before
lifting it out of the mixing material.
WARNING! Switch the product off, let it come to a complete stop and
remove the battery pack if the mixer paddle gets stuck in the mixing
material. Only then free the jammed attachment.
MNL_Erbauer_18V DC Paddle Mixer_EPM18-Li_V2_220117 II.indd 29 1/17/22 12:21 PM