Erbauer EPM18-Li - Troubleshooting

32
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product
does not
start
1.1. Battery pack is not properly
attached.
1.2. Battery pack is discharged.
1.3. Battery pack is damaged.
1.4. Other electrical defect to the
product.
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Check by a specialist
electrician
1.4. Check by a specialist
electrician
2. Product
does not
reach full
power
2.1. Battery pack capacity is too
low.
2.2. Air vents are blocked.
2.1. Charge battery pack
2.2. Clean the air vents
3. Unsatisfac-
tory result
3.1. Mixer paddle is worn
3.2. Mixer paddle is not suitable for
material to be mixed
3.1. Replace with a new one
3.2. Use appropriate mixer
paddle
4. Product
suddenly
stops
4.1. Product is overloaded.
4.2. Battery pack is discharged.
4.3. Battery is too hot.
4.1. Pull the mixer paddle
out of the mixing
material and switch it on
again
4.2. Remove and charge
battery pack.
4.3. Remove battery pack
and let it cool down.
5. Excessive
vibration or
noise
5.1. Mixer paddle is dull/damaged
5.2. Motor or bearings may be
damaged.
5.1. Replace with a new one
5.2. Have product checked
by a qualied service
agent.
MNL_Erbauer_18V DC Paddle Mixer_EPM18-Li_V2_220117 II.indd 32 1/17/22 12:21 PM