SQUIDS
®
TOOL ATTACHMENT
WWW.ERGODYNE.COM // 800 225 8238
INSPECTION
Inspect your tethering system before and after each use. All equipment should be
regularly inspected by a competent person. Ensure the tethering system is properly
attached to the tool and is not damaged. Before each use, check the following:
• Examine all hardware for rust or corrosion, abnormal distortion (twists, bends),
cracks or breaks, or any other damage.
• Examine markings on the product and labels for legibility.
• Inspect the other products (lanyards, anchor attachments, etc.) appropriately in
accordance with their instructions.
• If any part of the tethering system has knowingly been involved in a drop, it
must immediately be taken out of service and replaced. If any tethering system
component fails any part of an inspection, discard and replace the product
immediately.
DISCLAIMER
In no event shall Tenacious Holdings, Inc., be liable for any direct, indirect, punitive,
incidental, special, or consequential damages arising out of, or associated with, the
misuseof Squids® tethering system components (tool lanyards or attachments).
WARRANTY
We stand behind everything we make and guarantee our products to be free of
defects in materials and workmanship to the original purchaser for the product’s
lifetime. Damage, abuse, and/or normal wear are not covered. Questions? Call
Ergodyne at +1-651-642-9889 (8 a.m. - 5 p.m. CST) or 800-225-8238.
For translated product information
Para obtener informacion traducida del product
Pour obtenir des informations traduites sur les produits:
ergo.zone/translations
Rev. 12/22
To Next Page
Need help?
General
