The CADWELD
®
EXOLON Process
Fig. 7
Tighten the clamp thumbscrews onto the mold.
Fig. 8
Close the grips to tightly lock the mold. Check for an
appropriate seal on the mold.
Fig. 9
If the mold does not seal properly, make adjustments
to the handle clamp.
Fig. 10
Graphite absorbs moisture. Ignite the propane torch
and dry out the inside of the mold thoroughly on
both sides, heating the mold to approximately 250
degrees Fahrenheit (120 degrees Celsius).
21
To Next Page