CD 7012, ISSUE 2, 08/03/2015 5
Ericsson AIR 21/AIR 32 Mounting Instructions
PREPARING THE MOUNT FOR USE
** If the AIR 21/AIR 32 Mount is new, adjust the grip plate to the AAT with which it will be used.
Refer to the section on adjusting the grip plate near the end of this document if required.
1) Be sure that the mounting strap is installed in the mount and that the required bumpers are
in place and in good serviceable condition.
2) If you are using the AIR 21 mount (not the AIR 21/AIR 32 mount), there are no movable
threaded bumper/knobs. All bumper are in a fixed position, so skip to step 3. Otherwise,
continue with the following instruction.
** NOTE: The type and position of the rubber bumpers is fixed EXCEPT FOR THE TWO
THREADED BUMPERS/KNOBS. Do not use the mount without the fixed bumpers as well as
the two threaded bumpers/knobs. Moving, removing, or using the AIR 21/AIR 32Mount
with bumpers incorrectly installed, missing or damaged will result in inaccurate
measurements. **
To Next Page
Loading...
