Getting Started
1. Open Support > Licenses. Click the Browse button to locate the license key
file.
2. Click on the Upload button.
3. If licenses are required for both the base chassis and VCM option card then
multiple files will be provided (one for the base chassis and one for each slot
containing a card being licensed). All files need to be loaded onto the specific
unit.
4. Reboot the unit once all files have been loaded for the changes to take effect.
Note: The Front Panel CANNOT be used to upload license keys.
3.23 Alarm Monitoring
Alarms are reported on the GUI and Front Panel LED indication. Alarm trap
handling is also supported through SNMP.
The severity of an alarm can be changed or the alarm can be masked if required.
This can be performed on active alarms on the GUI dashboard or on any alarms by
browsing to the Support > Device Management page.
Figure 3.42 Alarm Monitoring
3.24 Simple Network Management Protocol
Simple Network Management Protocol (SNMP) is an application layer protocol that
facilitates the exchange of management information between network devices. It is
part of the Transmission Control Protocol/Internet Protocol (TCP/IP) protocol suite
and is defined in a set of standards (RFC 1065 - RFC 1067, RFC 1155 - RFC 1157,
RFC 1213, RFC 1441 - RFC 1452, RFC 1901 - RFC 1910, RFC 2576, RFC 3411 -
RFC 3418) published by the Internet Engineering Task Force (IETF).
To Next Page
Loading...