Front Panel Control
It is possible to configure the time before the keyboard becomes locked. This is
available in the Unit Config / Display Setup / Menu Display and Keypad menu of
the front panel or, from the GUI, go to Device Configuration > Advanced Setup >
Base Unit > Front Panel Parameters and set the Key Lock Time in the
Properties panel.
4.3 Front Panel Display
The parameters of the main display can be configured through the
Unit Config/Display Setup menu of the front panel.
4.3.1 Appearance and General Features
The parameters of the main displays for all models of the AVP are similar in content
and can be configured through the Unit Config/Display Setup menu of the front
panel.
When the power-up sequence is complete, if In-band Control is disabled, a main
screen is displayed showing the following features, see Figure 4.3.
Figure 4.3 Typical Screen Displayed on Power-Up (In-band Control Disabled)
When the power-up sequence is complete, if In-band Control is enabled, a main
screen is displayed showing the following features, see Figure 4.4.
Figure 4.4 Typical Screen Displayed on Power-Up (In-band Control Enabled)
To Next Page
Loading...