Ericsson AVP 3000 Series - How to Configure the AVP Using the Front Panel; How to Configure Video Parameters

Getting Started
EN/LZT 790 0023/1 R16A
3-69
3.25 How to Configure the AVP Using the Front Panel
The unit is fully configurable via the front panel. The most important parameters are
available under the dedicated menu items, while the full functionality of an option
card can be found under the Advanced menu. For the details of the interaction with
the front panel and the menu system, see Front Panel Control.
The configuration consists setting the general parameters of the base unit and the
option cards. Then, the output streams can be configured through the Output menu.
3.25.1 How to Configure Video Parameters
To configure the video parameters, select the AVP Encoder n menu and set the
parameters as listed in Figure 3.5.
Table 3.18 Video Parameter Settings
Parameter Setting Comment
Video Input Locked True, False. Read only parameter.
Video Bit rate 0.5 – 80 Mbps. Range and limits depends on video profile.
Video Profile
Off
SD MPEG2 Main Profile Main Level 4:2:0 8 bit,
SD MPEG2 4:2:2 Profile Main Level 4:2:2 8 bit,
SD H.264 Main Profile Level 3.0 4:2:0 8 bit,
SD H.264 High Profile Level 3.0 4:2:0 8 bit,
SD H.264 High Profile Level 3.1 4:2:0 8 bit,
SD H.264 Hi422 Profile Level 3.1 4:2:2 8 bit,
SD H.264 Hi422 Profile Level 3.1 4:2:2 10 bit,
HD MPEG2 Main Profile High Level 4:2:0 8 bit,
HD MPEG2 4:2:2 Profile High Level 4:2:2 8 bit,
HD H.264 Main Profile Level 4.0 4:2:0 8 bit,
HD H.264 High Profile Level 4.0 4:2:0 8 bit,
HD H.264 High Profile Level 4.1 4:2:0 8 bit,
HD H.264 Hi422 Profile Level 4.1 4:2:2 8 bit,
HD H.264 Hi422 Profile Level 4.1 4:2:2 10 bit.
SD J2K Profile Level 1 4:2:2 10 bit
HD J2K Profile Level 2 4:2:2 10 bit
HDp50/59.94 H.264 High Profile Level 4.2 4:2:0 8 bit
HDp50/59.94 H.264 Hi422 Profile Level 4.2 4:2:2 8 bit
HDp50/59.94 H.264 Hi422 Profile Level 4.2 4:2:2 10 bit
The availability of a profile depends on the option
card and the presence of a certain license.
Buffer Mode
CBR, Low Delay, Mega Low Delay, Compatibility, Ultra
Low Delay, Stripe Refresh, Stripe Refresh (+ Audio
Encode)
Available options depend upon the option card
and licenses.
Source Analogue, SDI, Color Bars, Black, Moving Object, Slate.
Configures the input source, which can be an
external video signal through the SDI connector or
the analogue CVBS connector on the back of the
VCM, or an internally generated test pattern.