Ericsson AVP 3000 Series - CE Option Modules; Digital Video Input (All CE-A and CE-X Option Modules)

Installing the Equipment
EN/LZT 790 0023/1 R16A
2-7
Table 2.6 Link Activity: Right (Yellow) LED
Link Speed LED Status
No Link Off
— — — — — — — — — — — — — — — — — —
Link On
☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐
Activity Flash
— ☐ — ☐ — ☐ ☐ ☐ ☐ ☐ — ☐ ☐ ☐ — ☐ ☐ ☐
2.3.4 CE Option Modules
The following connectors are provided on the CE Video Compression Modules.
2.3.4.1 Digital Video Input (All CE-a and CE-x Option Modules)
Standard and High Definition digital video can be input via
the 75 Ω female BNC connector (labeled 3G/HD/SD-SDI)
on the rear panel. The figure shows the SDI/HD-SDI type
75 Ω female BNC video input connector located on the
rear panel of the module. The LED (labeled LOCK) next
to the connector shows the lock status of the input video
signal.
Table 2.7 Digital Video Input via the SDI/HD-SDI Interface
Item Specification
Connector types 75 Ω female BNC
Connector designation 3G/HD/SD SDI IN
Pin-outs Centre
Shield
Input
Ground/Chassis
Table 2.8 Lock LED State Descriptions
Item Description
Off The SDI/HD-SDI Input is not active.
Red The SDI/HD-SDI Input is active, but not locked.
Green The SDI/HD-SDI Input is active and is locked.
Alternate Red and Green
The SDI/HD-SDI Input is active, but video with the wrong line standard is being
received.