Getting Started
When the Simplified View is to be used, outputs should either be all mirrored from
the main output, or should all be independent (but there are limitations associated
with this configuration). If other combinations are required then the advanced view
should be used.
When multiple outputs are configured as mirrored outputs, common TS parameters
that are defined by the main output are greyed out and read only for the mirrored
outputs.
3.20.1.4 Simplified View Summary
3.20.1.4.1 Immediate Action Banner - Output Configuration
The parameters, shown in the header banner, are immediately actioned on the unit,
when adjusted, without the need for an additional Apply. The parameters in this
banner are protected by the padlock to help prevent accidental changes to the
output configuration. This banner will show which outputs have been configured.
Toggle ON / OFF
Toggle Encryption ON / OFF
Lock / Unlock Banner
Toggle between power levels
Greyed out = read only
(mirrored output)
Increase / Decrease Power -
Enter Value or use arrows
Figure 3.31 Simplified View - Immediate Action Banner, All Outputs Configured:
SatMod (Main), IP and ASI Mirrored
Note: When the outputs are mirrored, the encryption buttons for the mirrored
outputs will be greyed out and read only. Toggling the main output
encryption on/off will also apply encryption to the mirrored outputs and the
button state updates to reflect this.
3.20.1.4.2 Configurable Parameters Requiring Apply Button
The remaining configurable parameters available on the Simplified View operate in
the same way as for the Advanced View, in that multiple changes can be made
which are not loaded onto the unit until the Apply button is pressed.
As with the Advanced View, changes that have not been applied are highlighted,
and the Apply and Discard buttons become active.
To Next Page
Loading...