Figure 3.61 Editing a BISS Key
Note: Although the BISS technical specification (Tech 3292 rev. 2.) states that
BISS Mode-E shall work with shorter BISS Mode-1 keys, this is not
supported in the unit. The Encrypted Session Word field only accepts 16-
digit keys.
4. When BISS has been enabled on a service a padlock will appear in the outputs
tree next to the service name and in Voyager units the Clear indicators on the
GUI banner and front panel will change to Scrambled.
5. It is possible to select which of the components of the service are to be
scrambled, when a BISS key has been selected. The choice of components can
be done at the service level or independently for each component. At the service
level, in the Service Configuration > Outputs > Service Properties widget,
open the Service > Scrambling accordion panel and select the components to
be scrambled.
Figure 3.62 Selection of Components to be Scrambled Using BISS
5. Selecting an individual component to be scrambled using BISS is performed on
the component tab of the Properties of that output component.
To Next Page
Loading...
