6. Set the Input Source to Embedded n (SDI 1), the embedded stream that
contains the left front and right front channels.
7. In the Properties widget, click on the Encode tab.
8. Select the required Coding Standard.
9. Select 3/2L (5.1 Surround) for Coding Mode.
Your 5.1 encoding is now set up.
3.7.29 How to Set Up Audio Transcoding on EI9001T
When transcoding video using an EI9001T card, only two audio components may be
transcoded and two audio components passed-thru. This is because the decoder is
restricted to two stereo pairs for decoded audio and two stereo pairs for pre-
compressed pass-thru components.
Figure 3.64 Transcoding Audio Using EI9001T Card
The current GUI operation, when dragging and dropping the components, makes
use of the Audio Decoder (daughter card) and will therefore restrict the number of
audio channels to be decoded to two stereo pairs. For that reason, transcoding 5.1
Dolby digital Channels is not possible using the audio decoder from the daughter
card.
Configuring Dolby Digital Transcoding from a TS Input Using the EI9001T
Card
To transcode Dolby Digital 5.1 audio streams, the decoder on the main card should
be used.
To Next Page
Loading...
