Figure 3.65 Manual Configuration of Dolby Digital Transcoding
Manually configure the audio as shown in the following steps:
1. Navigate to the Transcode Service window shown in Figure 3.66, configure the
incoming Audio as pass-thru.
Figure 3.66 Component Selection
2. Navigate to the Audio Component window shown in Figure 3.67.
3. Select the Input tab.
4. Select Dolby Digital from the Input Format drop-down menu.
5. Select Embedded 5 (SDI 1) from the Input Source drop-down menu.
Figure 3.67 Audio Component > Input
To Next Page
Loading...
