MGP Mode
Off, Module Level, Unit Level. Determines if MGP is enabled or not, or if it is enabled,
then the unit is controlled as a whole or on a module level basis.
Transmission Interval Period for steady-state transmission of MSM packets in units of ms.
R0 Playout Period Duration of the MSM burst emitted on entering MGP state R0 in units of ms.
S1 Playout Period Duration of the MSM burst emitted on entering MGP state S1 in units of ms.
Control Contact Timeout
Period of time in ms the system waits before assuming loss of contact with the control
system after the control link goes down.
MSM Destination Port UDP port for sending MGP packets.
MGP Settings
1
1
Only available when MGP is enabled
MSM Multicast Address The destination IP Address of the MSM packets.
MGP State The current state of the MGP implementation.
MGP Spares
2
2
Only available when MGP is enabled.
Spare Device Configuration Selects a spare device to set up its parameters.
Spare IP Address The IP address of another unit that is acting as a spare for this unit/service.
Vlan Tags
Output <n>: Data Port <m> - Data
Port <k>
Selects output <n> for adjusting its VLAN settings.
Add Vlan tag Adds a new VLAN tag to the current output.
Vlan ID: <id> The ID associated with the VLAN tag. Allows the user to change the ID.
Vlan ID (Create) Modifies the VLAN ID for the current tag.
Vlan IP Assigns an IP address to the VLAN.
Vlan Netmask Specifies the network mask for the current VLAN.
Vlan Gateway Specifies the gateway address for the current VLAN.
Vlan Priority Specifies the gateway priority for the current VLAN. 1-7.
SNMP
System Contact Contact to the team providing support for this unit.
System Name The name to identify the current unit.
System Location The location where the current unit is installed.
Will this unit be SNMP Polled True, False. Determines whether the unit is polled for SNMP information or not.
Time Elapsed before Control
assumed Lost
The amount of time between sysUpTime requests before the connection with the
control system is assumed to be down.
Currently in Contact with Control
System
Determines if a connection has been established with the trap server. True/False.
SNMP Agent Ready Determines if the SNMP agent is ready. True/False.
SNMP Trap Server Configures the Trap Server destinations.
Accept Configuration Accepts the changes in hardware configuration if there are any.
To Next Page
Loading...
