Parameter Values Description
Original Off, On Sets the original flag in the elementary stream header.
PES Packet Per
1
GOP, Picture
Determines how PES packets shall be generated. The
Picture option is only available if MPEG 2 encoding is
used.
AU Information Ctrl Off, RAI, RAI and AU Info
Controls insertion of Private Data in the TS Adaptation
Field for video Access Units (AU). This can be: Random
Access Indicator (RAI), ETSI 101 154 (AU info), Time
Code (TC) and Additional Info (Encoding info and
BroadcasterID).
AR Signaling
Location
1
Sequence Hdr, Picture Hdr, Seq and Pic Hdrs
In MPEG-2 encoding, signaling of the aspect ratio can be
in the sequence header, picture header or both.
Closed Captions
3
Off, ATSC Insert closed captions into the video bitstream.
TC Output Location
2
Off, SEI
Determines the locations used to transmit Time code
information in the stream. Time code can be carried by the
sequence header, the sequence and picture headers for
MPEG-2 or a SEI message for H.264.
1
Only present if encoding in MPEG-2.
2
Only present if encoding in H.264.
3
Only present for input sources at frame rates 29.97, 59.94 frames per second.
Video Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when a video component is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/Slot <x> Video Stream on PID <y> menu on the front
panel.
Table 5.13 Video Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed, Minimum, 2 to 20
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm.
Source PID Monitoring None, Monitor, Monitor & Redundancy
Priority 1 ETR290 monitoring on this PID can be enabled,
and can be set to cause a redundancy switch to a spare
device if in a system controlled by Ericsson control
software. Only used for IP sources.
5.5.3.1.2 Audio Stream Configuration
Audio Input
The following parameters are available on the Input tab of the Properties widget on
the Service Configuration page when an audio component is selected in the
Outputs widget. The same parameters can be accessed through the
Advanced/EI9001/Audio Module/Audio <n>/Input menu on the front panel.
To Next Page
Loading...
