Parameter Values Description
Network ID 1 to 65535 Identity of the network.
LCN Off; IEC 62216; NorDig v1; DTG default Logical Channel Number.
Send extended NIT
(SIRG)
Off; On
Insert NIT into PAT Yes; No
PSIP Information
ATSC Syntax Only.
MGT Off; On Master Guide Table generation.
STT Off; On System Time Table generation.
(T/C)VCT Terrestrial / Cable Virtual Channel Table generation.
EIT Event Information Table generation.
STT Parameters
GPS UTC Offset 0-255 seconds Time in seconds.
Daylight Saving Off; On Daylight Savings Time to be considered.
(T/C) VCT Parameters
Delivery Terrestrial; Cable Delivery mode.
Modulation Mode 8 VSB; 16 VSB Modulation mode of transmission.
Carrier Frequency 0 – 999 999 999 Hz Carrier frequency of transmission.
EIT Parameters
EIT Base PID 16 to 8190 PID of the first EIT.
Number of EITs 0 to 4 Number of tables in the SI.
5.5.4.1.2 Additional Settings for IP Output Transport Streams
The IP related Transport Stream parameters are available in the Properties widget
on the Service Configuration page if an IP output Transport Stream is selected in
the Outputs widget.
Table 5.60 Additional Settings for IP Output Transport Streams
Parameter Values Description
IP Bit Rate
Specifies the bit rate of the IP output and includes the
overhead added by IP encapsulation. Read only parameter.
TS Packets per IP
Packet
1 to 7
Specifies how many Transport Stream packets to encapsulate
in one IP packet.
IP Encapsulation
UDP, RTP, RTP FEC Column, RTP FEC
Column and Row
Specifies what higher layer to encapsulate in IP packets. UDP
and RTP is self explanatory and means that the Transport
Stream is first encapsulated in UDP or RTP packets, then an
IP header is added. If RTP FEC column or RTP FEC Columns
and Row is selected one (Column) or two (Column and Row)
RTP streams are output in addition to the RTP streams that
carry the Transport Stream.
Number of Rows The number of rows used in FEC encoding.
Number of Columns The number of columns used in FEC encoding.
To Next Page
Loading...
