Parameter Values Description
Alignment Block Aligned, Non Block Aligned The aligned method used for ProMPEG FEC.
MGP Settings
1 1
Only available in MGP Module Level mode and if the unit is not controlled by Ericsson control software
MSM Multicast
Address
IP v4 multicast address
Destination for MGP Status Messages. Transport streams
sharing this value belong to the same media bundle and are
switched on or off together.
MGP State
R0 Not In Service, S0 Not in Service, S1
Activated Spare, R1 On air
State of the bundle the transport stream belongs to. Read only.
IP Configuration/Destination 1
Destination IP
Address
aaa.bbb.ccc.ddd
The destination IP address to use in the IP packet header of
the IP packets that carry the Transport Stream
Destination UDP Port 0 to 65535
The destination UDP port to use in the IP packet header of the
IP packets that carry the Transport Stream
Source IP Address aaa.bbb.ccc.ddd
The source IP address to use in the IP packet header of the IP
packets that carry the Transport Stream
Source MAC Address Read only parameter, not yet supported.
Source UDP Port 0 to 65535
The source UDP port to use in the IP packet header of the IP
packets that carry the Transport Stream
Vlan Header Disabled, Enabled.
Vlan ID Tag
Vlan Tag The VLAN tag to use for the current IP stream.
Vlan Priority 0 to 7
The priority to be used by the switches to prioritize different
services.
Time To Live 0 to 240 TTL value for inclusion in the IP header
Type Of Service 0 to 255 ToS value for inclusion in the IP header
Actual source IP
address, calculated by
a rule
aaa.bbb.ccc.ddd The source IP address. Read only parameter
Actual source MAC
address, calculated by
a rule
The source MAC address. Read only parameter.
MGP Settings
1
Spare IP Address IP v4 address
Address used as source for MGP Status Message IP packets,
generally the IP address assigned to an output interface of a
peer (backup) unit.
Service Settings
The service parameters are available in the Properties widget on the Service
Configuration page if a service is selected in the Outputs widget. The same
settings are also available through the front panel under Output/<IP interface
name>/<Transport Stream name>/Service List/<service name>.
To Next Page
Loading...
