- Dolby Digital (56 kbps to 640 kbps) (software option CE/SWO/DOLBY/AC3).
- AAC LC/HE-AAC (32 kbps to 192 kbps) (software option CE/SWO/AAC).
- Pass-through of pre-encoded Dolby Digital (1 – 5.1 channels).
- Pass-through of pre-encoded Dolby E.
- Pass-through of uncompressed audio (Linear PCM – SMPTE 302M).
7.8.7 Indications
LEDs are provided to indicate SDI Lock Status.
7.9 Software and Firmware Upgrades
A single Upgrade Wizard is available for the unit and all option cards that can be
fitted for upgrading the unit software and firmware through the Ethernet control port.
To install software upgrade, navigate to the folder where the Upgrade Wizard is
saved, and run the executable file.
Notes: Follow instructions provided with the software upgrade wizard to reduce the
risk of upgrade failure.
The upgrade process needs approximately 50 minutes to finish. The unit
automatically reboots during the process.
Following an upgrade, the unit configuration is lost and any stored
configurations may no longer be compatible with the new software. A
configuration converter tool is available to convert existing configurations so
that they can be re-used. Refer to instructions provided with the converter
tool for more information.
To recover the unit from a failed upgrade, refer to the instructions provided
with the Upgrade Wizard.
7.10 Removal and Replacement of Modules
This section gives information relating to the handling of option modules as they are
inserted or removed from the unit.
To Next Page
Loading...
